No products in the cart.
Assistenza
+39-06-45425958
Spedizione gratis
per ordini oltre €150
Idee Regalo
-
Buoni Regalo
Offerta Gift Card 20€- 50€- 100€ Regala un buono -
Corsi Arduino-3D Printer
Arduino Micro:Bit Raspberry Robot Marttino
Nuovi prodotti
Gravity: Liquid Flow Sensor (G1/2)
Write your review
29,16 €
Tasse incluse
INTRODUCTION
This Gravity: Liquid Flow Sensor is designed based on the electromagnetic principle. It adopts O-ring rubber seal and uses silicone sealant at the outlet end to ensure good waterproofness. Also, it embraces high anti-electromagnetic interference and anti-vibration capabilities, offering reliable performance and long service life.
The sensor can be used with microcontrollers like Arduino UNO to measure the flow of liquids with high concentration and low viscosity like water, diesel, engine oil, milk, paint, detergent, honey, etc. (no impurity in liquid)
FEATURES
- Gravity interface, easy to wire
- Wide voltage of 3.5~24V
- Measure the flow of the high-concentration but low-viscosity liquid
- RoHS compliant
APPLICATIONS
- Measure the flow of liquids with high concentration and low viscosity
SPECIFICATION
- Operating Voltage: DC3.5~24V
- Operating Current: ≤10mA (DC5V)
- Output Mode: NPN pulse signal
- Pipe Diameter: G1/2
- Thread I.D.: 10mm
- Thread O.D.: 20.5mm
- Thread Length: 29mm
- Water Pressure Resistance: ≤1.2MPA
- Insulation Resistance: >100MΩ
- Flow Range: 30-1200L/H
- Error: ±1% (5-600L/H)
- Output Pulse High Level: >DC4.7V (input voltage DC5V)
- Output Pulse Low Level: <DC0.5V (input voltage DC5V)
- Output Pulse Duty Ratio: 50%±10%
- Flow & Pulse Correlation: 1L=150 pulses
- Operating Temperature: ≤80°C
- Operating Humidity: 35%~90%RH (No condensing)
- Storage Temperature: -25°~+80°C
- Storage Humidity: 25%~95%RH
- Dimensions: 80*47*37mm/3.15*1.85*1.46"
DOCUMENTS
SHIPPING LIST
- Gravity: Liquid Flow Sensor (G1/2) × 1