The FS5115M is a standard-size analog servo from FEETECH that can deliver more than twice the torque of our standard-size servos with plastic gears thanks to its powerful motor and all-metal gear train (if you need even more torque than this, check out the larger FT5335M giant servo). The output shaft is supported by two ball bearings for reduced friction. The FS5115M works with standard RC servo pulses, providing a running angle of approximately 180° over a servo pulse range of 500 µs to 2500 µs, and it has a 12? (30 cm) cable that is terminated with a standard JR-style connector, which is Futaba-compatible.

The servo cable is terminated with a Futaba-compatible JR-style connector.

FEETECH High-Torque Servo FS5115M with included hardware (actual hardware might vary).

The picture below shows the all-metal gear train that helps the servo deliver such high torque:

You can find more information about this servo in its datasheet (133k pdf).

Note that, as with most hobby servos, stalling or back-driving this servo can damage it. This servo can draw bursts of current in excess of 3 A at 6 V, so please make sure you have an appropriate power supply. For comparison, a typical standard-size servo might draw around an amp when straining.

Dimensions

General specifications